Pushbuttons - Leds And Lcd - Electrolux EWX11831 Service Manual

Pushbuttons – LEDs and LCD
3.2.2.3
The functions of each button are defined by the configuration of the appliance.

Button no. 1: ON/OFF
This button is always present, whatever the styling.
 Press it to turn the appliance on, at the same time the buzzer will
sound a tone (if enabled) and the LCD display lights up (the lighted
symbols are the ones for the programme).
 To switch the appliance off, press and hold the button for
approximately 1 second, after which the buzzer will sound
a tone (if enabled), the LCD display and the LEDs will switch off,
all the options selected and any programme that is running will
be cancelled.
The operation of the ON/OFF depends on the configuration of the
main circuit board. It can cut the appliance off from the electricity
mains completely (0 Watt circuit) or set the appliance to low energy
consumption mode (without 0 Watt circuit) in which case you will
need to take the plug out of the socket to cut off the electricity supply
completely.

Button no. 2: TEMPERATURE
This is related to the part of the LCD display in which the washing
cycle temperature is shown.
The starting temperature shown on the LCD display is the one set
for the programme selected.
Press this button in sequence to lower the temperature, when the
lowest temperature is reached the selection will start again from
the highest one available for the programme.
The temperatures available (displayed in °C) are:
95°C, 60°C, 50°C, 40°C, 30°C, 20°C, cold cycle.
The cold cycle is displayed by two dashes

Button no. 3: SPIN SPEED
This is related to the part of the LCD display in which the washing
cycle spin speed is shown.
The starting speed shown on the LCD display is the one set for
the programme selected.
Press the button in sequence to lower the speed. Once the lowest
speed selection is "Rinse hold" and the relevant symbol will light
up (if compatible with the programme selected). This is also
lit during the "Extra silent" programme.
The next selection will be the highest speed available for the
programme.
The spin speeds are: 1,600–1,400–1,200–1,000–800–600–
400– "Rinse Hold" cycle.
When no speed is selected, or the "Rinse Hold" cycle is selected,
the LCD display shows three dashes "

Button no. 4: OPTION
This button is configurable and is related to LED (L1). Depending
on the configuration of the appliance, it can perform the option of:
 Stains
 HOT & COLD water fill
Press this button to enable/disable the option associated with
it and turn LED L1 on/off respectively, at the same time the
programme time is updated (on the three digit display).
Technical Support - DMM
.
".
- - -
11/106
599 77 23-65 Rev. 03