Electrolux EWX11831 Service Manual page 35

- Door safety interlock
- Drainage pump
9
- Motor up to 650 rpm then at
10 -----
11 - Reading/Deleting the last alarm
- The LEDs light up in
12
÷
- When a button/sensor is
16
(*) In most cases, this time is sufficient to check the heating. However, the time can be increased by repeating the phase without draining the
water: pass for a moment to a different phase of the diagnostic cycle and then back to the heating control phase (if the temperature is higher
than 80°C, heating does not take place).
(**) The check at the maximum speed occurs without control of the A.G.S. and no garments must be inside the
Technical Support - DMM
maximum spin speed (**)
-----
sequence, the symbols on the
LCD display light up in in
groups and the backlighting
comes on
pressed, the group of icons on
the LCD display or the
corresponding LED lights up
and the buzzer sounds
Door closed
Water level lower
than anti-boiling level
for spinning
-----
-----
Always active
35/106
Drain, calibration
of analogue
pressure switch
Drum speed in
and spin
rpm/10
-----
----
User interface
functions
appliance.
599 77 23-65 Rev. 03
-----