Shock Absorbers - Electrolux EWX11831 Service Manual

16.6.7 Shock absorbers

Remove the back panel (see relevant chapter).
To take the pins out of their seats, push the locking tooth and
at the same time remove it with pliers.
Perform the same operations for the other pin.
Take the shock absorber out.
16.6.8 Welded tub assembly
Remove the worktop (see relevant paragraph).
Remove the control panel (see relevant paragraph).
Remove the front panel (see relevant paragraph).
Remove the detergent tray (see relevant paragraph).
Remove the upper counterweight (see relevant paragraph).
Remove the front counterweight (see relevant paragraph).
Remove the back panel (see relevant paragraph).
To remove the washing unit assembly, disconnect:
All the tub pipes, the wiring connectors that connect the heating element, the NTC probe, remove the belt and the
motor (to lighten the tub).
Lay the appliance on its back (making sure you place a polystyrene or cardboard layer on the floor to prevent
damaging the cabinet).
Take the tub out of the washing machine.
16.6.9 Drain pipe/cabling support
When fixing the drain pipe/cabling support make sure that the two stops
(indicated by the red arrows) fit into their housings, locking the support to
the unit.
If the fixing is not stable and there is a risk of it coming out of its position,
fasten the support to the unit with a screw (6.5x 3.5 mm) screwed into the
hole indicated by the blue arrow.
16.6.10 Drain pipe fastener
Loosen the screw that secures it to the cabinet.
Push it towards the inside while lifting it.
104/106
Technical Support - DMM 599 77 23-65 Rev. 03