Electrolux EWX11831 Service Manual page 21

 LCD
The information described below also appears on the LCD:

Programme phases:
The icons represented respectively mean:
1. Pre-wash
2. Wash
3. Rinse
4. Spin
5. Steam combined with the programme (where featured)
6. Rinse Hold
7. Excessive detergent
They light up during the programme setting where featured and during
their performance.
The icon representing the Overdosing lights up at the end of the cycle if
during the performance of the programme an excess production of foam
was detected.

Padlock:
The icon lights up when the "child lock" is on.
It indicates that all the buttons are disabled to prevent children from
modifying, starting or pausing the cycle.
To enable/disable this function, a key combination needs to be pressed.
It may be silk-screen printed on the control panel or described in the
instruction manual.

Door closed sensor:
Lights up when the safety device stops door opening and switches off
when the door can be opened.
Flashes when the device is about to unlock the door (with door interlock
with PTC, which needs one/two minutes to open).

Weight sensor:
Group of icons representing the weight information of the laundry inside
the drum.
Since they represent the maximum load possible, the actual weight of
the laundry inside the drum and the ratio of these two factors suggests
the quantity of detergent to pour into the detergent dispenser.
Description: see para. 5.2.1.7 on page 31

Washing programme time:
Description: see page 13

Delayed start:
Selected using the related button. After the START/PAUSE button is
pressed, the countdown starts and the delay time decreases hour by
hour, from a delay of 20 hours up to 2 hours  30'  60'  90'  2h
 3h... 20h  0h)
During the last 2 hours, it decreases by 30 mins at a time.
Press the button in sequence to increase the delay by 30' up to 10 hours,
whereas from 10 hours to 20 hours, the increase is of 1 (one) hour every
time the button is pressed.
During the programme selection phase, a delayed start can be
selected, from 30' to 20 hours (30'
 
20h 0h) and the time is shown on the display; during the final
hour the time shown decreases minute by minute.
during the last hour, the time decreases minute by minute.
To cancel the delayed start time, after the cycle has started, pause the
washing machine using the related button and cancel the option.
Technical Support - DMM
   
60' 90' 10h
21/106
1
4
11h...
2 3
5 6
7
599 77 23-65 Rev. 03