Table of Contents
Advertisement
2.9 Programme phase LEDs
When the programme has been selected, the LEDs
corresponding to the various phases in the programme light.
When the programme starts, only the LED corresponding to the
current phase remains lit.
LED
Colour
L26
Green
L27
Green
L28
Green
L29
Green
L30
Green
L31
Green
L32
Orange
L33
Green
Door LED
The following table shows the door LED the function:
Led Status
On
Flashing
Off
2.10 Display
The display shows the following information:
Three flashing hyphens: when a programme is cancelled by
pressing the SKIP/RESET button. The hyphens will also be displayed
when the ON/OFF button is pressed to switch the appliance on, but
only if the cycle selected previously has been cancelled.
The duration of the washing programme is displayed when the
programme has been selected. This time corresponds to the time
necessary for the maximum wash load.
When the programme is started (i.e. after pressing START/PAUSE),
the time is decremented at intervals of one minute.
The drying programme duration (washer-dryers), which is
displayed during the phase of selection of the drying time. After two
seconds the total time corresponding to half wash load is shown up.
In non-stop cycles the time results from the wash plus drying time.
SOI/DT 2002-06 eb
Models with Display
--
Prewash
Wash
Rinses
Spin
Drain
Drying (only for
Drying (only for
washer-dryers)
washer-dryers)
--
Meaning
While the cycle is performing with the possibility to open the door (in pause
mode)
Cycle in pause mode without the possibility to open the door (closed door)
While the cycle is performing without the possibility to open the door (in
pause mode) or door open
Door
Prewash
Prewash
Wash
Wash
Rinses
Rinses
Rinse hold
Spin
Drain
Drain
Filter Clogged
--
14
Models without Display
Door
Wash
Wash
Rinses
Spin
Spin
Drain
Filter Clogged
End
End
599 35 27-25
Advertisement
Table of Contents
