Drum Light - Electrolux EWX11831 Service Manual

Remove the small rod from the pin (after removal, it stays in the vertical
position).
Pull out the wiring protection from the door safety interlock.
Disconnect the connector.
To reassemble the door safety interlock, repeat the same tasks in reverse order.
Make sure the small rod is correctly positioned with respect to the door safety
interlock (see photo at the top of the page).
Make sure the small rod to release the door safety interlock is correctly positioned and visible in its seat by opening
the filter flap.
To reassemble the door safety interlock, repeat the same tasks in reverse order.
Before tightening the screws to secure the door safety interlock to the front
panel, make sure the flange is positioned properly on the outside as
indicated by the arrows.
Tighten the screws at a torque of 2.5 Nm.

16.3.3 Drum light

Remove the iron ring securing the bellow seal to the unit.
Remove the part of the bellow seal concerned from the unit.
Remove the wiring from the lamp holder.
90/106
Technical Support - DMM 599 77 23-65 Rev. 03