16.3.5
Blade
This blade is secured to the drum with slides and secured with blades
carved into the drum.
To remove it from the drum:
Insert a flat-tip screwdriver into hole 6 (see figure).
Place the screwdriver with the handle tilted towards the right.
Push the left-hand tab downwards.
Place the screwdriver with the handle tilted towards the left.
Push the right-hand tab down.
When the two tabs are down, move the blade towards the front of the drum,
and if necessary squash the blade at the two ends.
Technical Support - DMM
92/106
6
1
6
1
599 77 23-65 Rev. 03