Electrolux EWX11831 Service Manual page 28

The settings described below not only have the symbols of the options, but they are also accompanied by a
graphic bar within a frame. If the latter is lit, this means the option is enabled for the chosen programme.
Otherwise it remains off.
When all its segments are lit, it will start from scratch again the next time it is pressed.
 Sensor no. 3: OPTION
It is related to the part of the LCD display (see figure) where a
graphic bar and the symbols relating to the options are displayed,
depending on the chosen programme.
Touch the sensor with a finger and the graphic bar starts to light
up. The symbol for Stains is turned on at the same time.
As you continue, the Prewash symbol lights up.
The selection order is as follows:
1. Stains
2. Pre-wash
3. Stains + Prewash
4. Stains + Soak
5. No Option
It may happen that it is not possible to select the option(s) where
the stains item is displayed, due to the washing temperature being
too low, and consequently the options are skipped.
Concurrently to the displaying of the symbol for the option, as the
graphic bar is gradually illuminated, the name of the chosen
option is displayed in the text line in the top left.
 Sensor no. 4: EXTRA RINSE
It is related to the part of the LCD display (see figure) showing: the
graphic bar, a digit and the symbol for the "Extra rinse" option.
Touch the sensor with your finger and the graphic bar begins to
light up. Concurrently, the symbol lights up and you can choose
the number of rinses to add to the programme, which are
displayed by the digit (depending on the programme).
Concurrently to the displaying of the symbol for the option, as the
graphic bar is gradually illuminated, the name of the option is
displayed in the text line in the top left.
 Sensor no. 5: OPTION
It is related to the part of the LCD display (see figure) showing:
the graphic bar and the "Time save" option.
Touch the sensor with your finger, half or all of the graduated
scale may light up, depending on the configuration and the
related symbol also lights simultaneously.
Touch once
 and the chosen option is "Daily".
touch again and the graduated scale lights up completely
 the chosen option is "Super Quick".
Concurrently to the displaying of the symbol for the option, as the
graphic bar is gradually illuminated, the name of the chosen
option is displayed in the text line in the top left.

Sensor no. 6: DELAYED START
It is related to the part of the LCD display (see figure) showing:
the four digits and the text bar.
Touch the sensor with your finger. The LCD display is updated
according to the status of the door: if the door is open, the words
"Start delayed by" are displayed and the delay time is displayed in
the digits for approximately 5 seconds, whereas if the door is
closed, the words "Programme ending at" are displayed along
with the programme end time.
During the last hour, the time decreases minute by minute.
To cancel the delayed start time, after the cycle has started,
pause the washing machine using the related sensor (7) and
cancel the option.
Technical Support - DMM
28/106
599 77 23-65 Rev. 03