Switching The Signal Tone During A Seam Section Change On/Off - DURKOPP ADLER 550-12-33 Operating Instructions Manual

Programming
Operating Instructions 550-12-33/34 - 00.0 - 08/2017
Language Value on the display Designation on the display
Czech 3
Slovenian 4
Polish 5
Italian 6
Information
More information on the contents available in service mode can
be found in the  Service Instructions.
5.9.3 Switching the signal tone during a seam
section change on/off
The factory setting is for the machine to sound a signal tone every
time the seam section changes. The signal tone can be switched
on and off as needed.
To switch the signal tone on/off:
1. Open the User configuration menu ( p. 114).
▲/▼
2. Use to select the parameter Signal tone
(Forward Sound).
3. Confirm with OK.
 The submenu opens.
4. Confirm with OK.
5. Change the desired value using the
• 0 = the signal tone does not sound during a seam section
change
• 1 = the signal tone sounds during a seam section change
6. To go back one level in the menu, press the
 The changed value is stored immediately.
Jazyk
Jezik
Jezyk
Lingua
▲/▼
buttons.
◄
button.
115