DURKOPP ADLER 550-12-33 Operating Instructions Manual page 95

Programming
Operating Instructions 550-12-33/34 - 00.0 - 08/2017
Fig. 61: Creating a new seam program on the control panel (3)
9. To add a new seam section, press the upper softkey
 The display switches to:
Fig. 62: Creating a new seam program on the control panel (4)
Information
The bar on the display shows all seam sections.
In this case, the seam program consists of a single seam section.
The last section with the + sign indicates the option of adding
additional seam sections.
One seam program can be composed of up to 30 seam sections.
To duplicate a specific seam section, select the seam section
PRECEDING the section to be duplicated and press the upper
softkey .
To duplicate the 1st seam section, select the 1st seam section
and press the upper softkey
10. Next, add new seam sections or adjust the seam program
parameters first.
Information
If you wish to create several new seam sections for the new
seam program that contain parameters other than the preset
parameters, adjust the seam program parameters first before
adding new seam sections. As a general rule, the altered seam
program parameters only serve as the basis for future seam
sections. Existing seam sections must be adjusted individually.
.
.
93