Table of Contents
Advertisement
Setup
Fig. 95: Lubricating
③
①
②
(1) - Minimum level marking
(3) - Filler opening
(2) - Maximum level marking
All wicks and felt bits of the machine head are soaked in oil at the
factory. This oil is conveyed to the reservoir during use. This is
why you should avoid filling too much oil during initial filling.
Checking the oil level
Proper setting
The oil level must always be between the minimum level
marking (1) and the maximum level marking (2).
Topping off the oil reservoir
To top off the oil reservoir:
1. Fill oil through the filler hole (3) to a maximum of 2 mm below
the maximum level marking (2).
154
Operating Instructions 550-12-33/34 - 00.0 - 08/2017
Advertisement
Table of Contents
