Setting The Brightness Of The Display - DURKOPP ADLER 550-12-33 Operating Instructions Manual

Programming
Operating Instructions 550-12-33/34 - 00.0 - 08/2017
Function of the knee button
Menu entry Function
Set ruffling value to 0 and vice versa
No ~
(Manual mode)
Quick stroke adjustment: Switching maximum
Stroke
stroke on and off
Seam section change:
Segment
• go forward by one seam section each
• go forward no further than the last seam section
• To end the seam program and return to the
(Automatic mode)
Seam section change:
Seg. Beg
• go forward by one seam section each
• after the last seam section, go forward to the
6. To exit service mode, press the ESC button.
 The changed value is stored immediately.
5.9.7

Setting the brightness of the display

You can adjust the brightness of the display on the OP3000 control
panel as needed.
To adjust the brightness of the display:
1. Open the User configuration menu ( p. 114).
▲/▼
2. Use to select the Brightness parameter.
3. Confirm with OK.
4. Change the value using the
5. Confirm with OK.
6. To exit service mode, press the ESC button.
 The changed value is stored immediately.
within the seam program
beginning of the seam program, press the pedal to
the -2 position.
1st seam section of the same seam program
▲/▼
buttons.
119