Fluke 5520A Programmer's Manual page 25

Command Summary (cont)
Setup and Utility Commands (cont)
REFCLOCK_D?
REPHASE_D
REPHASE_D?
RTD_TYPE_D
RTD_TYPE_D?
SP_SET
SP_SET?
TC_TYPE_D
TC_TYPE_D?
Returns the power-up and
reset default for the reference
clock source (internal or
through the 10 MHz IN BNC
connector).
If two 5520As are
synchronized using 10 MHz
IN/OUT, sets the power-up
and reset default phase
difference between the
NORMAL terminals on the
slave 5520A and the NORMAL
terminals of the master 5520A.
If two 5520As are
synchronized using 10 MHz
IN/OUT, returns the power-up
and reset default phase
difference between the
NORMAL terminals on the
slave 5520A and the NORMAL
terminals of the master 5520A.
Set the default RTD sensor.
Returns default RTD sensor.
Sets serial HOST port settings.
Returns serial HOST port
settings.
Sets default TC sensor.
Returns default TC sensor.
23