Raising The Machine; Removing The Hood - Toro Workman HD 07369 Operator's Manual

Note: The rear slots are for a full bed installation and
front slots are for a 2/3 bed installation.
Note: The engine may need to be started to extend
or retract the cylinders for alignment with the holes.
Keep fingers out!
Note: The unused slot can be plugged with a bolt and
nut to prevent assembly errors.
5. Start the engine and engage the hydraulic lift lever
to raise the bed. Release the lift lever and turn off
the engine. Install the bed safety support to prevent
accidental lowering of the bed. Refer to Using the Bed
Safety Support.
6. Install the lynch pins to the inside ends of the clevis
pins.
Note: If the automatic tail gate release has been
installed on the bed, ensure that the front dump link
rod has been placed on the inside of the left side clevis
pin before the lynch pin is installed.

Raising the Machine

DANGER
A machine on a jack may be unstable and slip off of
the jack, injuring anyone beneath it.
• Do not start the machine while the machine is
on a jack.
• Always remove the key from the switch before
getting off of the machine.
• Block the tires when the machine is on a jack.
•
Do not start the engine while the machine is on a jack,
because the engine vibration or wheel movement could
cause the machine to slip off of the jack.
•
Do not work under the machine without jack stands
supporting it. The machine could slip off a jack, injuring
any one beneath it.
•
When jacking up the front of the machine, always place a
2 x 4 block (or similar material) between the jack and the
machine frame.
•
The jacking point at the front of the machine is under the
front center frame support (Figure 30) and at the rear it is
under the axle (Figure 31).
1. Front jacking points
1. Rear jacking points

Removing the Hood

1. While grasping the hood in the headlight openings, lift
up on the hood to release the lower mounting tabs
from the frame slots (Figure 32).
32
Figure 30
Figure 31