Toshiba B-FV4 Series Manual page 228

7. B-FV Setting Tool
Print Darkness
Print Speed
Unit (Label)
Width
Height
Unit (Position
Adjustment)
X-coordinate
Y-coordinate
Tear Off
COM
The COM tab provides the settings of the RS-232C port. When you use COM as your port, make
sure the settings in the COM tab are the same as the port settings, or your printer won't work
properly.
Adjust the darkness relative to the current darkness setting.
The range is 0 ~ +30, and the value is adjustable in increments of ±
1.
Determine the media speed during printing. The range is +2 ~
+6, and the value is adjustable in increments of ± 1 ips.
mm Change the unit of label to millimeter.
inch Change the unit of label to inch.
Set the print width.
Set the length of the label when using continuous media.
Change the unit of Position Adjustment to millimeter.
mm
Change the unit of Position Adjustment to inch.
inch
dots Change the unit of Position Adjustment to dots.
Move the print position horizontally. The positive number is left, and
the negative number is right.
Move the print position vertically. The positive number is
forward, and the negative number is backward.
Adjust the rest position of the media after a label is printed, which
changes the position at which the label is torn or cut.
7-94
7.6 Working with B-FV Setting Tool (V1.0.34)
EO18-33030