Toshiba B-FV4 Series Manual page 124

6. SYSTEM MODE
4 ips.
25. Forward Wait
It defines the action before or after the printing. When it is set to ON, your printer moves the paper
forward in a predefined length 1 second after printing, and pulls the paper back in a predefined length
once the printing begins again; when it is set to OFF, your printer won't move the paper at all.
26. Auto Calibration
There are three modes for auto calibration: ON (Power on), ON (Power on and Head close), OFF. When
it is ON (Power on), your printer calibrates the media sensor automatically once it restarts or is turned on.
When it is ON (Power on and Head close), your printer calibrates the media sensor automatically every
time you close the print module when your printer is turned on. When it is OFF, you need to calibrate the
media sensor manually as you change the media, or your printer won't work properly.
27. Multi Label
When it is enabled, your printer prints an image across label gaps if the print image is larger than a label;
when it is disabled, your printer only prints the part that one label can contain.
28. Auto TPH Check
When it is enabled, your printer checks broken pins on the printhead automatically once your printer is
turned on.
29. BASIC
Enable or disable the BASIC Interpreter.
30. Flash ROM
The total flash memory size
31. SDRAM
The total SDRAM size
32. USB Serial Number
The USB serial number of your printer
33. Information
The first line is the name of your printer. The second line is the serial number of your printer.
34. Total Feed1
It counts the total print length, including the length of cutting, peeling, tearing and feeding.
35. Total Feed2
It counts the total length of printing and the forward feed, excluding the length of cutting, peeling, tearing
and the backfeed. The unit in the first line is centimeter, and the second line is inch.
36. Total Print
It counts the total print length of the print area.
37. Total Cut
It counts the times the cutter cuts.
38. Baud Rate
The rate of signals transmitted per second.
6-11
EO18-33030
6.5 Self-Test Printing / Dump Mode