Toshiba B-FV4 Series Manual page 122

6. SYSTEM MODE
1. Program Version
The firmware version and date
2. TPCL Version
The TPCL emulation version
3. CG Version
The TPCL English font version
4. Chinese Version
The TPCL Chinese font version
5. Codepage Version
The TPCL codepage version
6. Boot Version
The boot version
Boot is a piece of code that runs when your printer is turned on. It copies necessary files into the SDRAM,
and executes them from the specified address in the SDRAM. Boot can also restore the firmware if it is
corrupted.
7. Kernel Font Version
The built-in printer fonts, including bitmap and TrueType
8. WLAN Option Installation
This item shows whether or not the Wireless LAN interface option is installed.
9. Bluetooth Option Installation
This item shows whether or not the Bluetooth interface option is installed.
10. HW Detect
It detects the hardware installed on your printer. The table below shows the meaning of each value from
right to left:
16 15 14
0 0 0
1  0: no RTC, 1: with RTC.
2  0: no ribbon sensor, 1: with ribbon sensor.
3  0: no peeler/take-off sensor, 1: with peeler/take-off sensor.
4  0: no cutter, 1: with cutter.
5-6  00: no wireless module, 01: with wireless LAN module, 10: with Bluetooth module,
11: with RFID module.
7  0: no Ethernet, 1: with Ethernet.
8-9  Reserved.
10  0: no USB flash drive, 1: USB flash drive attached.
11-12  00: Main board, 01: DT Courier, 10: DT Global, 11: TT Global.
13  0: partial cutter, 1: full cutter.
14-16  Reserved.
13 12 11 10 9
0 1 0 0 0
8 7 6 5 4
0 0 1 0 0
6-9
6.5 Self-Test Printing / Dump Mode
3 2 1
Bit
0 0 0 Value
EO18-33030