Toshiba B-FV4 Series Manual page 184

7. B-FV Setting Tool
Property Name
Subnet Mask (Current TCP/IP)
Gateway (Current TCP/IP)
Socket
Port Number
SNMP
DHCP
Host Name
Client ID
Trap 1
Trap 2
Setting up LAN Connection
If you want to use the LAN or Multi-LAN port to transfer data, you need to set up the network
connection in the LAN tab.
1.
Connect your printer and computer to a network device (hub, switch or router) with Ethernet
cables.
The current subnet mask of your printer.
The current gateway of your printer.
Enable The host communicates with your printer via the
socket.
Disable Disable the socket.
The LAN port number of your printer.
Enable The host gets or sets parameters registered as
SNMP entities.
Disable Disable SNMP.
Enable The DHCP server assigns the IP address, the
subnet mask and the gateway to your printer automatically.
By default, it is enabled.
Disable You need to specify the IP address, the subnet
mask and the gateway to your printer manually.
It is the name of a DHCP client. The host name allows up to
32 alphanumeric characters. You can leave it blank or type a
name you want. By default, there is no host name.
It is an arbitrary value sent to the DHCP server to reserve an
IP address for your printer. Client ID allows up to 32
hexadecimal characters. If you leave it blank, your printer
automatically assigns
"FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF" as the client
ID.
Trap is a message type of SNMP. When Trap 1 is enabled
and its IP address is set correctly, your printer alerts the
computer of the specified IP address as your printer is
experiencing problems.
Same as Trap 1.
7-50
7.4 Working with B-FV Setting Tool (V1.0.27)
Description
EO18-33030