Toshiba B-FV4 Series Manual page 227

7. B-FV Setting Tool
2) When getting the value from the printer
The Setting value is transmitted as dot information from the printer.
Case
Case 3
Case 4
"mm/inch ⇔ dot" conversion always has a calculation difference in converting units. These are
cases where the setting value entered in the Setting Tool may change slightly due to requirements
of the conversion process.
e.g. In case of 3.2 mm setting :
3.2 / 25.4 × 203 = 25.5 = > 25 dot (Sending value to the printer)
25 x 25.4 / 203 = 3.12 = > 3.1 mm (Getting value from the printer)
Property Name
Sensor Type
Ribbon Sensor
Auto Calibration
Reprint After Error
Conversion process
mm => dot
inch => dot
It is the media sensor you are using. It includes Reflective,
Transmissive and Continuous. When you perform media
calibration, the sensor is set to the one you select.
Enable (Thermal Transfer) Your printer uses the ribbon sensor to
detect the ribbon, it is mean Thermal Transfer (TT).
Disable (Direct Thermal) Disable the ribbon sensor, it is mean
Direct Thermal (DT).
ON (Power on) Your printer automatically calibrates media using a
media sensor once it restarts or is turned on.
ON (Power on and Head close) Your printer automatically
calibrates media using a media sensor every time you close the print
module when the printer is turned on.
OFF You need to manually calibrate media using a media sensor
as you change the media, or your printer won't work properly.
Enable Your printer when caused by the error condition. The label
is reprinted as soon as the error condition is corrected.
Disable Disable the reprint after error.
7.6 Working with B-FV Setting Tool (V1.0.34)
Calculation (Setting value = B)
203dpi B × 25.4 / 203
300dpi B × 25.4 / 300
203dpi B / 203
300dpi B / 300
Description
7-93
EO18-33030
Rounding method
Rounded down to
the 1st decimal
place.
e.g. 2.183 ->2.1
Rounded down to
the 2nd decimal
place.
e.g. 2.117 ->2.11