Toshiba B-FV4 Series Manual page 182

7. B-FV Setting Tool
Property Name
Width
Height
X-coordinate
Y-coordinate
Tear Off
COM
The COM tab provides the settings of the RS-232C port. When you use COM as your port, make
sure the settings in the COM tab are the same as the port settings, or your printer won't work
properly.
Property Name
Baud Rate
Data Length
Parity
Set the print width. The range is 0 ~ +101.6, and the value is
adjustable in increments of ± 0.1 mm.
Set the length of the label when using continuous media. The range
is 0 ~ +5461.0, and the value is adjustable in increments of ± 0.1
mm.
Move the print position horizontally. The positive number is right, and
the negative number is left. The range is -800 ~
+800, and the value is adjustable in increments of ± 1 dot.
Move the print position vertically. The positive number is
forward, and the negative number is backward. The range is -
800 ~ +800, and the value is adjustable in increments of ± 1 dot.
Adjust the rest position of the media after a label is printed, which
changes the position at which the label is torn or cut. The range is
-12.0 ~ +12.0, and the value is adjustable in increments of ± 0.1 mm.
The rate of signals transmitted per second. The larger the number,
the faster the data transmission.
The length of the data transmitted. It can be set to 7 or 8 bits.
It can be set to Odd, Even or None. A parity bit is added to a string
of data bits to check if the data is correct.
Odd The total number of "ones" in the data plus the parity bit is an
odd number.
Even The total number of "ones" in the data plus parity bit is an
even number.
7-48
7.4 Working with B-FV Setting Tool (V1.0.27)
Description
Description
EO18-33030