Screens And Settings; Set Ch Setpoint/ Dhw Setpoint Directly Via The Status Overview; Entering The Menu - Slant/Fin VGH-299-CH Installation And Service Manual

Screens and settings.

This screen is active during power up and will remain active until communication with the Main Control (the AL-
BUS) has been established.
After communication has been established the following Status overview appears:
59.0 °F
59.0 °F
This screen shows on the bottom the "CH setpoint" temperature.
On the middle left the outdoor temperature (if sensor is connected).
12.2.1 S CH
ET SETPOINT
When CH is active, you can adjust the
When DHW is active, you can adjust the DHW setpoint directly on the bottom of the Status overview.
This means that when CH is active, you cannot set the DHW setpoint directly via the Status overview. When
DHW is active, you also cannot set the Actual setpoint (CH setpoint) directly via the Status overview.
Press UP/DOWN ↑↓ to select the mode, then press CONFIRM
Actual/DHW setpoint becomes directly settable. Use UP ↑ or DOWN ↓ to increase/decrease the setpoint.
Press CONFIRM or RIGHT → to confirm your alteration or press ESC
A setpoint is only visible on the display when no error or alert is active. In case of an active error or alert, the
bottom right part of the display is used to display the error or alert text.
12.2.2 E
NTERING THE MENU
Enter the menu by pressing the MENU
menu. While scrolling through the menu you will see that the selected menu item is shown in a white rectangle.
Central Heating (CH)
Domestic Hot Water (DHW)
Information
Settings
Enter a menu item by pressing CONFIRM
The header shows your location inside the menu, as seen in the following image:
If you are inside the menu (or a menu item) and want to return directly to the Status overview press
MENU or ESC If you want to go back one step in the menu press BACK/LEFT ← .
Central Heating (CH)
Picture 12. 2
176.0 °F
176.0 °F
Picture 12. 3
/ DHW
SETPOINT DIRECTLY VIA THE
CH setpoint directly on the bottom of the Status overview.
button once. The header in the display shows you are inside the main
▼
Picture 12. 4
or RIGHT →.
170 °F
Picture 12. 5
E93.1601EN032.C VGH installation manual
S
TATUS OVERVIEW
or RIGHT → to confirm the mode and the
or LEFT ← to cancel.
65