Driveprogramming Restart - Omron RX2 Series User Manual

3 Operation Procedure for DriveProgramming
3-3-5

DriveProgramming Restart

You can restart the stopped program by performing the following operations. When the program is
restarted, all tasks are started simultaneously from the beginning.
• When the DriveProgramming Function Selection (UE-02) is set to 01 ([PRG] terminal): a reset input
via the control circuit terminal while the PRG terminal is ON, or turning ON the PRG terminal again.
• When the DriveProgramming Function Selection (UE-02) is set to 02 (Always): a reset input via the con-
trol circuit terminal, or turning ON the power supply for the inverter again.
Precautions for Correct Use
• You cannot restart the DriveProgramming by pressing the STOP/RESET key of the LCD Operator.
Set data 28 (RS:Reset) to input terminal 1 to 9, A and B. After that, turn ON that terminal.
• When the Reset mode selection (CA-72) is set to 00 (On to Release Trip) or 01 (Off to Release Trip), the
DriveProgramming can be restarted by a reset input even when there is no trip.
 Restart when the EzSQ function enable (UE-02) is set to 01 ([PRG] terminal):
Input terminal 1 to 9, A and B
 Restart after trip when the EzSQ function enable (UE-02) is set to 02 (Always)
(without "on trip goto" command):
3 - 14
Power ON
Power supply
PRG terminal
[PRG] terminal
ON
Start
Task1
Start
Task2
Start
Task3
Start
Task4
Start
Task5
Power ON
Power supply
Start
Task1
First
Start
Task2
First
Start
Task3
First
Start
Task4
First
Start
Task5
First
PRG terminal OFF PRG terminal PRG terminal OFF
ON
Stop
Start
First First
Stop Start
First First
Stop Start
First First
Stop Start
First First
Stop
Start
First First
Trip Trip reset Power OFF
Stop Start
First
Stop Start
First
Stop Start
First
Stop Start
First
Stop Start
First
DriveProgramming User's Manual (I622-E1)
Power OFF
Stop
Stop
Stop
Stop
Stop
Stop
Stop
Stop
Stop
Stop