Omron RX2 Series User Manual page 148

6 DriveProgramming Commands
 Example
In the above example, the start/end operation of the timer (0) is repeated when X(01) is not 0. If X(01)
changes to 0, the timer is stopped and X(01) is monitored.
Block number
1 Assigns 20 to U(01).
2 Jumps to the block 1: loop_ if X(01) is 0. Goes to the next step if X(01) is not 0.
3 Starts the timer (0) for the "timer set" command with the set value U(01).
4 to 9 Monitors X(01) and jumps to the block 10: LB0001_ when TD(0) is 1 and X(01) is not 0.
When X(01) changes to 0, the timer (0) stops and the program goes to the next step.
10 Jumps to the block 1: loop_ unconditionally.
6 - 52
Flowchart Text
Operation
DriveProgramming User's Manual (I622-E1)