Siemens SINUMERIK 802D sl Function Manual page 460

Index
Tapping with compensation chuck G63, 413
Thread cutting G33, 411
Fixed point positions, 151
Fixed stop, 73
Following block velocity, 67
Following error compensation, 226
G
Gantry
Referencing and synchronizing, 90
Gantry axes
Terms, 86
Gear stage change in master/slave, 402
Grooves, 237
Grouping auxiliary functions, 160
H
Hand wheel
Traversal in JOG, 145
Traversing the axes, 139
Hardware limit switches, 142
I
Implicit exact stop, 62
INC, 371
Incremental travel, 144
Indexing axes
Coded position, 375
Coded positions, 372
Continuous traversal, 370
Handwheel, 371
Incremental traversal (INC), 371
Parameterization, 373
Programming, 375
Reference point approach, 370
Startup, 376
Traversal from PLC, 372
Input resolution, 117
Interpolator end, 61
Interpolatory compensation
Compensation table, 209
Linear interpolation, 210
J
Jerk limit, 64
Jerk limitation, 64
460
JOG
Approaching a fixed point, 148
L
Language command
SPN, 283
SPP, 282
Leading axis, 87
Leadscrew error compensation (LEC), 210
Linear axis
Limit switch monitoring, 50
Traversing range, 116
with rotary encoder on motor, 130
LookAhead, 66
M
Master-slave, 391
Measuring accuracy, 253
Measuring system error compensation (LEC), 210
Mode change, 169
Monitoring of the input signal, 277
Motion monitoring functions, 41
O
Offset angle, 385
Operating modes
Error on operating mode changeover, 169
Interlocks, 172
Mode change disable, 169
Monitoring, 171
Overload factor, 64
P
Parameter sets of the position controller, 134
Part program interruption, 174
Path axes, 59
Path feedrate F, 409
Alarms, 410
Feedrate for G63 (tapping with compensation
chuck), 413
Feedrate with G33 (thread cutting), 411
Value range, 116
Path segmentation, 280
Pathrelated jerk limitation,
Permanently assigned PLC axis, 308
Physical quantities, 118
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
Turning, Milling, Nibbling