Data Lists; Machine Data; Interface Signals - Siemens SINUMERIK 802D sl Function Manual

Axis control
If an axis is in the neutral state, it can be controlled by the signals AXRESET, AXSTOP and
AXRESUME, effective in the channel.
If during acceleration it is detected that an axis which was defined as a geometry axis
simultaneously has been defined as permanently assigned PLC axis, the axis function will be
denied with alarm 4320 axis 1% function MA_BASE_FUNCTION_MASK Bit5 and
MC_AXCONF_GEOAX_ASSIGN_TAB.
If a change to a PLC axis is not possible
In case of a traverse request from the VDI interface area, an illegal change to a PLC axis is
ended with the start signal "Competing positioning axis active" at the VDI interface.
Note
Competing positioning axes get their block end points exclusively from the PLC an can be
started at any point in time.
17.3

Data lists

17.3.1

Machine data

Number
Axis/spindle-specific
30460
32060
17.3.2

Interface signals

Number
Signals to channel
V3200 0006
V3200 0007
V3200 0007
Signals from channel
V3300 0004
Signals to axis/spindle
V380x 3000
V380x 5004
V380x 5004
Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
Identifier
BASE_FUNCTION_MASK
POS_AX_VELO
Bit Name
.0 Feed disable
.1 NC Start
.4 NC stop axes plus spindle
.3 All axes stationary
.7 Start positioning axis
.1 AxReset
.2 AxResume
Positioning Axes (P2)
Description
Axis functions
Feedrate for positioning axis
17.3 Data lists
311