Setting Data; Interface Signals - Siemens SINUMERIK 802D sl Function Manual

Spindle (S1)
20.9 Data lists
Number
35130 * GEAR_STEP_MAX_VELO_LIMIT[n]
35140 * GEAR_STEP_MIN_VELO_LIMIT[n]
35150 SPIND_DES_VELO_TOL
35160 SPIND_EXTERN_VELO_LIMIT
35200 * GEAR_STEP_SPEEDCTRL_ACCEL[n]
35210 * GEAR_STEP_POSCTRL_ACCEL[n]
35300 SPIND_POSCTRL_VELO
35310 SPIND_POSIT_DELAY_TIME[n]
35350 SPIND_POSITIONING_DIR
35400 SPIND_OSCILL_DES_VELO
35410 SPIND_OSCILL_ACCEL
35430 SPIND_OSCILL_START_DIR
35440 SPIND_OSCILL_TIME_CW
35450 SPIND_OSCILL_TIME_CCW
35500 SPIND_ON_SPEED_AT_IPO_START
35510 SPIND_STOPPED_AT_IPO_START
36060 STANDSTILL_VELO_TOL
36200 * AX_VELO_LIMIT [n]
36300 ENC_FREQ_LIMIT
36302 ENC_FREQ_LIMIT_LOW
36720 DRIFT_VALUE
The machine data marked with * is contained in the parameter set for a gear stage.
20.9.2

Setting data

Number
General
41200
Spindle-specific
43210
43220
43230
20.9.3

Interface signals

Number
Axis-specific
VD30x 0000
366
Identifier
Identifier
JOG_SPIND_SET_VELO
SPIND_MIN_VELO_G25
SPIND_MAX_VELO_G26
SPIND_MAX_VELO_LIMS
Bit Name
- M function for the spindle (DINT), axis-specific
Maximum speed of gear stage
Minimum speed of gear stage
Spindle speed tolerance
Spindle speed limitation via PLC
Acceleration in speed control mode
Acceleration in position control mode
Position control activation speed
Positioning delay time
Positioning direction of rotation for a nonsynchronized spindle
Reciprocating speed
Oscillation acceleration
Starting direction during oscillation
Oscillation time for M3 direction
Oscillation time for M4 direction
Feed enable with spindle in setpoint range
Feed enable with stationary spindle
Threshold velocity "Axis/spindle stationary"
Threshold value for velocity monitoring
Encoder limit frequency
Encoder limit frequency resynchronization
Drift basic value
JOG velocity for the spindle
Programmable spindle speed limit G25
Programmable spindle speed limit G26
Programmable spindle speed limit G96
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
Name
Name
Turning, Milling, Nibbling