Data Lists; Machine/Setting Data - Siemens SINUMERIK 802D sl Function Manual

Feed (V1)

24.4 Data lists

The spindle override is active with G33, but it should not be actuated for reasons of
accuracy; also active with G331, G332. In the case of G63, the spindle override is set to a
fixed value of 100%.
Override active
The set override values are effective in all operating modes and machine functions. This
applies if the IS "Rapid traverse override active", "Feedrate override active" or "Override
active" are set.
An override factor of 0% acts as a feedrate disable.
Override inactive
When the override is inactive (i.e. the above interface signals are set to "0"), the override
factor "1" is used internally for all switch positions (except from the 1st position), i.e. the
override is 100%.
Note
The 1st switch position of the Gray-coded interfaces for the value represents a special case.
In this case, the override factor of the 1st switch position is also used if the IS "Rapid
traverse override active", "Feedrate override active", "Override active" are not set. Thus 0%
is issued as the override value for axes (acts the same as "Feed disable"). The following
applies to the spindle if the IS "Override active" is not set: Override value 50%.
24.4 Data lists
24.4.1

Machine/setting data

Number
General machine data
10240
Channel-specific machine data
20201
Axis-specific machine data
32000
35100
Channel-specific setting data
42100
420
Identifier
SCALING_SYSTEM_IS_METRIC
CHFRND_MODE_MASK
MAX_AX_VELO
SPIND_VELO_LIMIT
DRY_RUN_FEED
Name
Basic system metric
Specifications regarding the chamfer/rounding
behavior
Maximum axis velocity
Maximum spindle speed
Dry run feedrate
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
Turning, Milling, Nibbling