Siemens SINUMERIK 802D sl Function Manual page 168

Operating Modes, Program Operation (K1)
10.2 Operating modes
Possible machine functions in MDA
The following machine function can be selected in the MDA operating mode:
TEACH IN (insert program blocks)
The required machine function is activated with IS "TEACH IN" (V3000 0001.0). The display
is visible in the IS "Active machine function TEACH IN" (V3100 0001.0).
Stop
A stop signal can be issued with the following interface signals
● IS "NC stop" (V3200 0007.3)
● IS "NC stop axes plus spindles" (V3200 0007.4)
● IS "NC stop at block limit" (V3200 0007.2)
Depending on the interface signal used, either only the axes or in addition the spindles of the
channels are stopped or the axes at block end.
RESET
The active part program is aborted by the IS "Reset" (V3000 0000.7).
The following actions are executed when the IS "Reset" is triggered:
● Part program preparation is stopped immediately.
● Axes and spindles are stopped.
● Any auxiliary functions of the current block not yet output, are no longer output.
● The block indicator is reset to the beginning of the relevant part program.
● All Reset alarms are deleted from the display.
● The reset is complete as soon as IS "Channel status Reset" (V3300 0003.7) is set.
Ready
Ready to run is displayed by IS "802 Ready" (V3100 0000.3).
168
Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0