Ke8950 Point-To-Point Installation - ATEN KE6900T User Manual

KVM over IP Matrix System User Manual

KE8950 Point-to-Point Installation

Setting up the KE8950 / KE8952 system in a point-to-point configuration is
simply a matter of plugging in the cables.
Note: In a point-to-point configuration, no administrator setup is necessary.
Make sure that all the equipment is powered off. Refer to the installation
diagrams on the next two pages and do the following:
1. On the transmitter side, plug the mouse, keyboard, HDMI monitor,
microphone and speakers into the ports on the Console section of the
KE8950T / KE8952T. Each port is marked with an appropriate icon to
indicate its function.
2. Connect the USB HDMI KVM cable provided with this package into the
KVM Ports on the front of the KE8950T / KE8952T.
3. Connect the other end of the USB HDMI KVM cable into the keyboard,
video, mouse, speaker and microphone ports on the computer.
4. For control of serial devices, connect the RS-232 serial port on the
transmitter to a serial port on the computer.
5. Connect a Cat 5e/6 cable to the KE8950T / KE8952T's LAN port, or a
Gigabit Ethernet (GbE) optical fiber cable to the SFP port.
6. Plug the power adapter into an AC source; then plug the other end into the
KE8950T / KE8952T's power jack.*
7. On the receiver side, plug the mouse, keyboard, HDMI monitor,
microphone, and speakers into the ports on the Console section of the
KE8950R / KE8952R.
8. Connect the other end of the Cat 5e/6 cable to the KE8950R / KE8952R's
LAN port; or the other end of the Gigabit Ethernet (GbE) optical fiber
cable to the SFP port.
9. Plug the second power adapter into an AC source; then plug the other end
into the KE8950R / KE8952R's power jack.*
10. Power on the computer.
Note: Power adapters are not provided with KE8952 units. Please contact
your ATEN dealer to purchase additional power adapters.
72