KVM over IP Matrix System User Manual
KE6900 Point-to-Point Installation
Setting up the KE6900 / KE6940 system in a point-to-point configuration is
simply a matter of plugging in the cables.
Note: In a point-to-point configuration, no administrator setup is necessary.
Make sure that all the equipment is powered off. Refer to the installation
diagrams on the next two pages and do the following:
1. On the Transmitter side, plug the mouse, keyboard, DVI monitor,
microphone and speakers into the ports on the Console section of the
KE6900T / KE6940T. Each port is marked with an appropriate icon to
indicate itself.*
2. Connect the USB KVM cable provided to the KVM Ports on the front of
the KE6900T / KE6940T.
3. Connect the other end of the USB KVM cable to the keyboard, video,
mouse, speaker and microphone ports on the computer.
4. For control of serial devices, connect the RS-232 serial port on the
Transmitter to a serial port on the computer.
5. Connect a Cat 5e/6 cable to the KE6900T / KE6940T's LAN port.
6. Plug the power adapter into an AC source; and plug the other end into the
KE6900T / KE6940T's Power Jack.
7. On the Receiver side, plug the mouse, keyboard, DVI monitor,
microphone, and speakers into the ports on the Console section of the
KE6900R / KE6940R.**
8. Connect the other end of the Cat 5e/6 cable to the KE6900R / KE6940R's
LAN port.
9. Plug the second power adapter into an AC source; and plug the other end
into the KE6900R / KE6940R's Power Jack.
10. Power on the computer.
Note: 1. If installing the KE6940 with two DVI monitors, connect the second
DVI monitor via a DVI cable into the additional ports on the KE6940
and computer.
2. A keyboard or mouse with special functions may need to use the USB
ports for advanced features to work (see USB Mode, page 177).
66