Edid Command - ATEN KE6900T User Manual

EDID Command

Extended Display Identification Data (EDID) is a data that contains a display's
basic information and is used to communicate with the video source. The EDID
commands allow you to change the EDID setting of a Transmitter. For more
information on configuring EDID settings, see Properties, page 115.
The formula for the EDID command is as follows:
Command + Address + Number + Control + [Enter]
1. For example, if you want to configure device (192.168.0.3) to use the
remix EDID mode, type the following:
edid a192.168.0.3 remix [Enter]
The following tables show the possible values for the EDID commands:
Command
edid
Address
Number
Control
auto
remix
default
manual
EDID command
a Address command
xx Address number
xx: Receiver ID or IP address
Checks the EDID of all connected
displays and uses the best resolution for
all displays.
Checks the EDID of all connected
displays and the source device uses the
best common resolution for all displays
(see EDID Mode, page 123).
Implements ATEN's default EDID.
(default)
Manually set the EDID configuration from
the Receiver's OSD (see EDID Mode,
page 123).
Chapter 12. CLI Commands
Description
Description
Description
Description
245