Ke9950R / Ke9952R (Receiver) Rear View - ATEN KE6900T User Manual

KVM over IP Matrix System User Manual

KE9950R / KE9952R (Receiver) Rear View

No. Component
1 Grounding Terminal
2 Reset
3 Audio Ports
4 USB Port
5 Power Jack
6 Function Switch
7 RS-232 Port
48
The wire used to ground the unit connects here.
This switch must be pushed with a thin object, such as
the end of a paper clip.

Press and release to reboot the device.

Power off, hold reset then power on the device
while pressing reset to recover from a firmware
upgrade failure.

Press and hold it in for more then three seconds
resets the unit back to its factory default
settings.
These mini stereo ports are for the local speakers
(green) and microphone (pink).
Use this port for virtual media or a USB peripheral
device.
Note: 1. When using a USB disk plugged into this
port, see USB Mode, page 177.
2. This USB port does not support isochronous
endpoints, therefore USB peripherals that
stream audio or video data, such as
speakers or webcams, will not work.
The cable from the DC Power adapter connects here.
Use this slide switch to set the unit's mode:

Extension: Sets the device to use the normal TX to
RX extension mode.

RS-232 Config: The device is ready to be
configured via serial commands through the RS-232
port.
This RS-232 serial port is for connecting to a serial
terminal.
Description