Exit Osd; Default Ip Addresses - ATEN KE6900T User Manual

 IP Address– sets the IP address for the KE device. Key in a valid
unique IP address.
Note: See Default IP Addresses, page 99, for the preconfigured
factory-default settings.
 Subnet Mask – sets the subnet mask for the KE device. Key in a valid
subnet mask value.
Note: The default setting is 255.255.255.0
 Default Gateway– sets the default gateway for the KE device. Key in a
valid default gateway.
6. Click Save.

Exit OSD

To exit the OSD, press [Esc] on the keyboard, click Logout; tap the Scroll
Lock key twice; or return to the OSD main page and press the front panel OSD
pushbutton (Receiver only).
At this point the Receiver can connect to the Transmitter to access the remote
computer (see Connecting, page 120 for instructions).

Default IP Addresses

The preconfigured factory-default IP addresses for the KE Series devices are
as follows:
Transmitters – 192.168.0.61
Receivers – 192.168.0.60
Chapter 2. Hardware Setup
99