Chapter 12. Cli Commands; Serial Control Protocol Commands; Configuring The Serial Port - ATEN KE6900T User Manual

Serial Control Protocol Commands

The KE Series's built-in bi-directional RS-232 serial interface and LAN port
connection allows system control via Receivers through a high-end controller
or PC. This control feature can also be accessed via TCP/IP through a computer
running Telnet. The port for Telnet commands should be set to 9130.

Configuring the Serial Port

The controller's serial port should be configured the same as the Receiver's
default configuration, as shown below:
The Receiver's Function Switch should be set to RS-232 Config (see page 27).
Before executing RS-232 commands across a network you must install the KE
Matrix Manager software on a computer and ensure that it is online. For the
Slim Version of KE Series (KE8900ST/8900SR/9900ST). Please make sure
the RS-232 Serial Port is not connected before executing commands.
On your computer, open a terminal (command line) session. Please press "U/
u" to start "CLI Session".
Baud Rate
Data Bits
Parity None
Stop Bits
Flow Control None
Chapter 12
CLI Commands
9600
8
1
235