Mazda RX-8 Manual page 1069

D Range Test
1. Perform road test preparation. (See Road Test Preparation .)
2. Shift the selector lever to the D range.
3. Accelerate with the throttle half and then wide open.
4. Verify that 1→2, 2→3, and 3→4 upshifts can be obtained. The shift points must be as shown in the
table below.
If there is any malfunction, inspect the TCM and AT. (See SYMPTOM TROUBLESHOOTING
•
ITEM TABLE .)
5. Drive the vehicle in 4GR, 3GR, and 2GR and verify that kickdown occurs for 4→3, 3→2, 2→1
downshifts, and that the shift points are as shown in the table below.
If there is any malfunction, inspect the TCM and AT. (See SYMPTOM TROUBLESHOOTING
•
ITEM TABLE .)
6. Decelerate the vehicle and verify that engine braking effect is felt in 2GR, 3GR, and 4GR.
If there is any malfunction, inspect the TCM and AT. (See SYMPTOM TROUBLESHOOTING
•
ITEM TABLE .)
7. Drive the vehicle and verify that TCC operation is obtained. The operation points must be as shown in
the table below.
If there is any malfunction, inspect the TCM and AT. (See SYMPTOM TROUBLESHOOTING
•
ITEM TABLE .)
Shift point table
Range Mode Throttle condition Shift
D NORMAL
Wide open
Vehicle speed
(km/h {mph})
→ D
D 6066 {3840}
1 2
→ D
D 108116 {6771}
2 3
→ D
D 160170 {100105} 6,0006,350
3 4
TCC ON (D ) 175185 {109114} 4,5504,800
4
Turbine speed
(rpm)
6,3006,850
6,2506,700
(w) RX-8 Transmission (Manual & Auto)
Page 44