Configure Port Mirroring - NETGEAR S350 Series User Manual

S350 Series 8-Port Gigabit Ethernet Smart Managed Pro Switch Models GS308T and GS310TP
6. To clear all counters, click the Clear button.
All statistics for the trap logs are reset to their default values.
The following table describes the Trap Log information that is displayed on the page.
Table 63. Trap Logs information
Field
Number of Traps Since Last
Reset
Trap Log Capacity
Number of Traps since log
last viewed
Log
System Up Time
Trap

Configure Port Mirroring

Port mirroring lets you select the network traffic of specific switch ports for analysis by a
network analyzer. You can select many switch ports as source ports but a single switch port
only as the destination port. You can configure how traffic is mirrored on a source port by
selecting packets that are received, transmitted, or both.
A packet that is copied to the destination port is in the same format as the original packet on
the wire. This means that if the mirror is copying a received packet, the copied packet is
VLAN-tagged or untagged as it was received on the source port. If the mirror is copying a
Description
The number of traps that occurred since the switch last rebooted.
The maximum number of traps stored in the log. If the number of traps exceeds
the capacity, the entries overwrite the oldest entries.
The number of traps that occurred since the traps were last displayed. Displaying
the traps by any method (terminal interface display, web display, upload file from
switch, and so on) causes this counter to be cleared to 0.
The sequence number of this trap.
The time when this trap occurred, expressed in days, hours, minutes, and
seconds, since the last reboot of the switch.
Information identifying the trap.
Monitor the System
302