NETGEAR S350 Series User Manual page 304

S350 Series 8-Port Gigabit Ethernet Smart Managed Pro Switch Models GS308T and GS310TP
You can configure one destination port only. The port functions as a probe port and
receives traffic from all configured source ports. If no port is configured, None is
displayed. The default is None.
8. Click the Apply button.
Your settings are saved.
In the Source Interface Configuration section, perform the following steps.
9. Use one of the following methods to narrow down the ports that are displayed:
• Select 1 to display the physical ports. (This is the setting.)
• Select LAG to display a list of LAGs only.
• Select CPU to display the CPU.
• Select All to display a list of all physical ports, LAGs, and CPU.
10. Use one of the following methods to select one or more source ports:
• Select a specific interface by specifying the interface number using the respective
naming convention (for example, g1 or l1) in the Go To Interface field and clicking the
Go button. See
entry corresponding to the specified interface is selected.
• Select one or more check boxes in the Interface column.
Traffic from the selected ports will be sent to the destination port.
11. From the Direction menu, specify the direction of the traffic that must be mirrored from the
selected source ports:
• None. No traffic direction is selected. This is the default setting.
• Tx and Rx. Monitors both transmitted and received packets.
• Rx. Monitors received (ingress) packets only.
• Tx. Monitors transmitted (egress) packets only.
12. Click the Apply button.
Your settings are saved.
The Status field indicates the interface status.
Interface Naming Conventions
Monitor the System
304
on page 26 for more information. The