NETGEAR S350 Series User Manual page 254
8-port gigabit ethernet smart managed pro switch
Hide thumbs
Also See for S350 Series:
- User manual (365 pages) ,
- Hardware installation manual (30 pages) ,
- Product setup sheet (4 pages)
Table of Contents
Advertisement
S350 Series 8-Port Gigabit Ethernet Smart Managed Pro Switch Models GS308T and GS310TP
The previous figure does not show all columns.
6.
From the ACL Name menu, select the MAC ACL.
7.
In the Sequence Number field, enter a whole number in the range from 1 to 2147483647 to
identify the rule.
8.
From the Action menu, select the action that must be taken if a packet matches the rule's
criteria:
•
Permit. Forwards packets that meet the ACL criteria.
•
Deny. Drops packets that meet the ACL criteria.
9.
In the Assign Queue field, specify the hardware egress queue identifier that must be used
to handle all packets matching this ACL rule.
The range for the queue ID is from 0 to 7.
10.
From the Mirror Interface menu, select the specific egress interface to which the matching
traffic stream must be copied, in addition to being forwarded normally by the switch.
This field cannot be set if a redirect interface is already configured for the ACL rule. This
field is visible for a Permit action.
11.
From the Redirect Interface menu, select the egress interface to which the matching traffic
stream must be redirected, bypassing any forwarding decision normally performed by the
switch.
This field cannot be set if a mirror interface is already configured for the ACL rule.
12.
From the Match Every menu, select whether each Layer 2 MAC packet must be matched
against the rule:
•
True. Each packet must match the selected ACL rule.
•
False. Not all packets need to match the selected ACL rule.
13.
In the CoS field, specify the 802.1p user priority that must be compared against the
information in an Ethernet frame.
The range for the priority is from 0 to 7.
14.
In the Destination MAC field, specify the destination MAC address that must be compared
against the information in an Ethernet frame.
The format is xx:xx:xx:xx:xx:xx. The BPDU keyword can be specified using a destination
MAC address of 01:80:C2:xx:xx:xx.
15.
In the Destination MAC Mask field, specify the destination MAC address mask that must
be compared against the information in an Ethernet frame.
The format is xx:xx:xx:xx:xx:xx. The BPDU keyword can be specified using a destination
MAC mask of 00:00:00:ff:ff:ff.
16.
From the EtherType Key menu, select the EtherType value that must be compared against
the information in an Ethernet frame.
Manage Device Security
254
Hide quick links:
Advertisement
Table of Contents
