Modify Igmp Snooping Settings For A Vlan - NETGEAR S350 Series User Manual

S350 Series 8-Port Gigabit Ethernet Smart Managed Pro Switch Models GS308T and GS310TP
• Fast Leave Mode. Enable or disable the IGMP snooping fast leave mode for the
specified VLAN ID. The default is Disable.
• Host Timeout. Set the value for group membership interval of IGMP snooping for the
specified VLAN ID. The range is from the value for the Maximum Response Time plus
1 to 3600 seconds. The default is 260 seconds.
• Maximum Response Time. Set the value for the maximum response time of IGMP
snooping for the specified VLAN ID. The range is from 1 to the Host Timeout value
minus 1. This value must be greater than group membership interval value. The
default is 10 seconds.
• MRouter Timeout. Set the value for multicast router expiry time of IGMP snooping for
the specified VLAN ID. The range is from 0 to 3600 seconds. The default is
0 seconds.
• Report Suppression Mode. Enable or disable IGMP snooping report suppression
mode for the specified VLAN ID. IGMP snooping report suppression allows the
suppression of the IGMP reports sent by the multicast hosts by building a Layer 3
membership table. The results is that only the most essential reports are sent to the
IGMP routers so that the routers can continue to receive the multicast traffic.The
default is Disable.
• Querier Mode. Enable or disable the IGMP querier mode. The default is Disable.
• Query Interval. Set the IGMP query interval for the specified VLAN ID. The range is
from 1 to 1800 seconds. The default is 60 seconds.
8. Click the Apply button.
Your settings are saved.

Modify IGMP Snooping Settings for a VLAN


To modify IGMP snooping settings for a VLAN:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Switch on page 11.
Your web browser might display a security message, which you can ignore. For more
information, see
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
Access the Local Browser Interface
Configure Switching
Change the Default IP Address of the
on page 19.
156