Garmin G1000 Pilot's Manual page 63

If GPS is the selected bearing source, the active waypoint identifier is displayed in lieu of a frequency. If an
active waypoint is not selected, the bearing pointer is removed from the HSI and "NO DATA" is displayed in
the information window.
Selecting bearing display and changing sources:
1) Press the PFD Softkey.
2) Press a BRG Softkey to display the desired bearing pointer and information window with a NAV source.
3) Press the BRG Softkey again to change the bearing source to GPS.
4) Press the BRG Softkey a third time to change the bearing source to ADF (note: ADF radio installation is
optional).
5) To remove the bearing pointer and information window, press the BRG Softkey again.
DME INFORMATION WINDOW
Refer to the Audio Panel and CNS Section for information on tuning the radios.
NOTE:
DME radio installation is optional.
NOTE:
The DME Information Window is displayed above the BRG1 Information Window and shows the DME
label, tuning mode (NAV1, NAV2, or HOLD), frequency, and distance. When a signal is invalid, the distance
is replaced by "–.– – NM".
Displaying the DME Information Window:
1) Press the PFD Softkey.
2) Press the DME Softkey to display the DME Information Window above the BRG1 Information Window.
3) To remove the DME Information Window, press the DME Softkey again.
Distance to
Bearing Source
Bearing Pointer
Source
190-00595-00 Rev. A
DME
DME Label
Information
Tuning Mode
Window
Frequency
Distance
Station
Identifier
Bearing 1
Icon Information
Window
Figure 2-26 HSI with Bearing and DME Information
Garmin G1000 Pilot's Guide for the Beechcraft A36/G36
Bearing 1 Bearing 2
Pointer Pointer
Bearing 2
Information
Window
FLIGHT INSTRUMENTS
No
Waypoint
Selected
Pointer Bearing
Icon Source
2-17