Garmin G1000 Pilot's Manual page 307

ILS APPROACH
Flying an ILS approach:
1) Transition from GPS Navigation Mode to Heading Select Mode.
a) Load the Runway 29R ILS approach for KFAT into the Flight Plan and select 'Vectors to Final' for the transition.
b) Set the Selected Heading after getting vectors from ATC and press the HDG Key. The autopilot turns the aircraft
to the desired heading.
2) Use Heading Select Mode to comply with ATC vectors as requested.
3) In preparation for approach, tune the localizer frequency and select LOC mode on the HSI.
4) Press the APR Key when cleared for approach to arm LOC Approach and Glideslope modes.
The autopilot and flight director determine when to begin the turn to intercept the final approach course.
5) The autopilot flies the ILS Approach. At the Decision Height, there are two options:
a) Push the AP DISC Switch and land the aircraft
OR :
b) Use the GA Button to execute a missed approach (refer to the following procedure).
190-00595-00 Rev. A
1
Figure 7-26 ILS Approach to KFAT
Garmin G1000 Pilot's Guide for Beechcraft A36/G36
AUTOMATIC FLIGHT CONTROL SYSTEM
Clovis
V ORTA C
( CZQ )
KFAT
2
3
5
SANGO
4
7-27