3.5 Installing the Cart Brake Release
CAUTION: It is important that the brake-release handle be mounted in an
ergonomically-suitable location, so an Operator can repetitively release the
brakes without risking injury.
The actual mounting location and procedure for the brake-release handle are not covered here
due to the variability that is possible in cart structure designs. Ensure that no part of the cart
brake-release cable bends more than a 76 mm (3 inches) radius.
There is a 6.4 mm (0.25 inch) horizontal hole through the rear horizontal tube of the cart. See
the following two figures.
6-mm dia. (0.25-inch dia.) Pass-through hole
for brake cable, through rear frame tube
54
Figure 3-22. Brake-release Lever
Figure 3-23. Thru-hole for Brake-release Cable
LD Platform Cart Transporter User's Guide
14766-000 Rev E