Table of Contents
Advertisement
10.6 Removing and Installing LD Platform Cart Transporter Covers
2. Reconnect the cabling to the latching motor assembly and its sensors.
3. Reinstall the eight M6 screws along the sides and front of the top plate.
Use the screws previously removed from the top plate.
4. Reinstall the two M5 screws that were covered by the Latching Mechanism cover.
Use the screws previously removed from the top plate.
Installing Latching Mechanism Cover
1. Place the Latching Mechanism cover back onto the top plate.
2. Reinstall the four M3 screws holding the Latching Mechanism cover to the top plate.
Use the screws previously removed from the Latching Mechanism cover.
These go into four 45 mm standoffs in the top plate.
10.6 Removing and Installing LD Platform Cart Transporter Covers
Many of the maintenance procedures require removing some of the platform's covers. Most
covers are held in place with just magnets. The rear outer cover has an additional brace at the
bottom for support, the bumper cover uses screws and magnets, and the access panel uses just
a push-push (toggle) latch.
The covers are:
Rear Inner (Battery)
l
Access Panel
l
Left Side, Right Side
l
Both side covers include a light disc and cover.
Front Upper
l
Bumper
l
Rear Outer
l
With the exception of the bumper cover, no tools are needed for either the removal or install-
ation of the covers.
Removing Covers
NOTE: After removing covers, place them inner-side down, so the outer surfaces
don't get scratched.
The covers can be removed in the order in which they are listed above.
152
CAUTION: Pinch hazard. The magnets holding the covers in place are strong
enough to pinch you if you are not careful.
LD Platform Cart Transporter User's Guide
14766-000 Rev E
Advertisement
Table of Contents
