Table of Contents
Advertisement
Low Front Laser
1. Remove the four M5 screws holding the laser guard to the mounting plate along with
their lock washers and flat washers.
This will free the guard from the plate.
Retain the M5 screws, lock washers, and flat washers for reassembly.
2. Remove the two M4 screws, lock washers, and flat washers holding the laser to the
plate.
This will free the laser from the plate.
Retain the two screws, lock washers, and flat washers for reassembly.
3. Disconnect the laser cable from the cable to the platform core.
Cut the cable ties holding the cable to the cable tie anchors.
4. Connect the platform core cable to the new laser's cable.
5. Mount the new laser to the plate with the M4 screws, lock washers, and washers pre-
viously removed.
NOT
USED
6. Mount the laser guard to the plate with the M5 screws, lock washers, and washers pre-
viously removed.
Take care not to scratch the laser lens during this procedure.
7. Cable-tie excess cable to the two anchors so it cannot touch the floor or the tires.
14766-000 Rev E
CAUTION: Take care not to scratch the laser lens during this pro-
cedure.
Guard, Front
Laser Mount
Chassis
NOT
USED
Guard, Rear,
to Chassis
NOT USED
Cable Tie Anchors
Underside
Figure 10-13. Mounting Plate for Low Front Laser and Guard
LD Platform Cart Transporter User's Guide
Chapter 10: Maintenance
M5
M4
THRU
NOT USED
Cable Tie Anchors
Top Side
161
Advertisement
Table of Contents
