Table of Contents
Advertisement
3.4 Setting Up an LD Platform Cart Transporter
Repacking for Relocation
If the LD Platform Cart Transporter or other equipment needs to be relocated, reverse the steps
in the installation procedures in this chapter. Reuse the original packing crates and materials
and follow all safety notes used for installation. Improper packing for shipment will void your
warranty.
The LD Platform Cart Transporter must always be shipped in an upright orientation.
3.4 Setting Up an LD Platform Cart Transporter
The LD Platform Cart Transporter is shipped with the HMI post installed. This includes the
Operator panel at the top of the HMI post. You will have to:
Roll the transporter off of the crate, down the ramp
l
This will be rolling on the casters, not the drive wheels.
Remove the pins holding the drive wheels up
l
Install the battery
l
Install the dock, for charging the transporter's battery
l
This should have already been removed from the crate.
Set up your wireless system
l
This is covered in Settings and Configuration on page 59.
Rolling the LD Platform Cart Transporter off of the Crate Base
1. Install the crate front onto the crate base, to serve as a ramp.
There are two hanger bolts that stick up out of the front of the crate base. These fit into
two holes in the end of the ramp. Orient the ramp as shown in Figure 3-7. to ensure
there is a smooth transition between the ramp and the ground.
40
Figure 3-6. Crate Braces
LD Platform Cart Transporter User's Guide
14766-000 Rev E
Advertisement
Table of Contents
