Table of Contents
Advertisement
6. Remove the brake pin with spring from the inner brake cable wire.
Save the brake pin and spring for reassembly.
7. Pull the brake cable inner wire up far enough to be out of the way for removing the
caster mounting screw.
8. Unscrew the caster mounting screw, to remove the caster assembly from the cart body.
Retain the caster mounting screw and lock washer for mounting the new caster.
Rear Caster Installation
1. Unscrew the lock nut from the axle going through the new caster wheel.
Retain the lock nut for reassembly.
2. Remove the axle and caster wheel from the caster. Do not discard.
Retain the axle and caster wheel for reassembly.
3. Attach the caster body to the cart body using the caster mounting screw and lock
washer previously removed.
Take care not to damage the brake cable inner wire.
NOTE: Do not use threadlocker on the rear caster mounting screws.
Torque to 73.2 N·m (54 ft-lbf).
4. Push the brake cable inner wire back into the cable housing, so the ball end slides out of
14766-000 Rev E
Shaft of Pin Slides
Inside Caster
Mounting Screw
Blunt End Presses
Against Caster Wheel
Figure 10-21. Brake Pin
LD Platform Cart Transporter User's Guide
Chapter 10: Maintenance
Brake Cable Wire,
with Ball End, Fits
into Slot and Hole
Flat Top of
Blunt End
Retains Spring
173
Advertisement
Table of Contents
