LG PRCKD42E Owner's Manual page 20

CONTROL KIT INSTALLATION
20
Control Kit Outdoor Unit Box
(PRCH56A1) Installation
Use the outdoor unit box to install the Control
Kit in the following order.
- Drill holes after determining the location to
install the outdoor unit box of the Control Kit.
- Check the location of the holes behind the
outdoor unit box and installation materials.
4 holes
<Outdoor box backside>
Product name Specification Quantity(EA)
Washer M10, SUS
Bolt M10X 70, SUS
Nut M10, SUS
Washer M10, SUS
- Match the drilled holes with the outdoor unit
box holes, and fasten the unit with bolts,
nuts and washers.
Nut (4EA)
Washer
(4EA)
4-Ø12 hole
Location
4 Outdoor box enclosed
4
Control Kit
4
enclosed
4
Washer (4EA)
Bolt (4EA)
- Mount the Control Kit inside the installed
outdoor unit box. Remove the nuts from the
bolts inside the outdoor unit box to fasten
them as shown below.
Control Kit
Narrow the gap
between the brackets
and fasten the nut.
- After the installation is completed, check to
see if the modifications were made as
shown below.
!
CAUTION
• Do not install the Control Kit alone. It can
cause injuries.
• After installing the product, check to see
if it's installed securely in place.
• After installing the product, adjust the
space between the brackets for fasten-
ing the electric wires at the bottom of
the outdoor unit box to block the wire
hole. (Rats and other small animals can
enter the box and damage the wires.)
• After installing the product, check the
security status of the AHU and outdoor
unit connection. Failure to ensure the
security can cause information leak.
• Make sure to use an outdoor unit box to
protect the Control Kit when installing
the AHU outdoors.
Washer
(4EA)
Nut (4EA)