Table of Contents
Advertisement
WARNING:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•
Procedure
•
Procedure
•
Post-requisites
Procedure
1
Align the slots on the system fan with the rubber grommets on chassis.
2
Route the rubber grommets through the slots on system fan and pull the rubber grommets until the fan snaps into position.
3
Connect the system-fan cable to the system board and place the computer in an upright position.
Procedure
1
Align the four captive screws on the processor-cooling assembly with the slot on the system board.
2
Align the tabs on the fan with the slots on the chassis and place the fan in position.
computer. After working inside your computer, follow the instructions in
Replacing the fan
After working inside
www.dell.com/
Replacing the fan
22
39
Hide quick links:
Advertisement
Table of Contents
