Replacing The Processor; Procedure; Post-Requisites - Dell Inspiron 5676 Service Manual

WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
CAUTION: If either the processor or the heat sink is replaced, use the thermal grease provided in the kit to ensure that thermal
conductivity is achieved.
NOTE: A new processor ships with a thermal pad in the package. In some cases, the processor may ship with the thermal pad
attached to it.
Topics:
•

Procedure

•

Post-requisites

• Post-requisites
Procedure
1 Ensure that the release lever on the processor socket is fully extended in the open position.
CAUTION: The pin-1 corner of the processor has a triangle that aligns with the triangle on the pin-1 corner on the processor
socket. When the processor is properly seated, all four corners are aligned at the same height. If one or more corners of the
processor are higher than the others, the processor is not seated properly.
2 Align the notches on the processor with the tabs on the processor socket and place the processor in the processor socket.
CAUTION: Ensure that the processor-cover notch is positioned underneath the alignment post.
3 When the processor is fully seated in the socket, pivot the release-lever down and place it under the tab on the processor cover.
4 Place the computer in an upright position.
Post-requisites
1 Replace the processor-cooling assembly
2 Replace the right-side cover.
computer. After working inside your computer, follow the instructions in
or processor fan.

Replacing the processor

42
After working inside
www.dell.com/
Replacing the processor 73