9.
After closing the cover, if there are still wrinkles or slack on the printing surface at
the center of the table, push both ends of the tray lightly and push the fabric
under the table.
After closing the cover, check that the fabric is not caught between the cover and the tray.
Loading Socks in the Sleeve & Socks Tray
When you want to print on socks, use the Sleeve & Socks Tray.
• To use Sleeve & Socks Tray, you need to install the latest firmware (ver. 1.20 or later) on
the machine.
•
If you perform printing with the edges of the fabric still outside of the table, the fabric or
this machine might be damaged. After fixing the fabric, make sure that it fits within the
width of the tray.
•
Do not forcibly lift or twist the table. Doing so may cause a failure.
1.
Press the [Power] key, and then turn on the machine.
Detach the tray after turning on the machine. If you detach the tray before turning on the
machine, turn it off first, and then turn it on again.
2.
Make sure that the tray stand is out of the machine, and then detach the tray.
If it is not out of the machine, press the [Tray] key to eject the tray.
Lift up the tray lightly and pull the tray to detach it.
•
DSA048
DSA049
Loading Fabrics
61